Free field frequency response ±6 dB |
36 Hz ... 21 kHz |
Free field frequency response ±3 dB |
39 Hz ... 20.4 kHz |
Pass band free field frequency response |
42 Hz … 20 kHz, ±1.25 dB |
Free field frequency linearity deviation between 100 Hz and 10 kHz |
±0.8 dB |
Self-generated noise at 10 cm (with input gain set to 100 dB SPL for 0 dBu) |
<20 dB(A) SPL |
Sine wave output with a THD < 0.5 % at 1 m in half space |
95 dB SPL (>75 Hz) |
Max. SPL calc. in half space at 3% THD at 1m (averaged between 100 Hz and 6 kHz) |
118.7 dB SPL |
Max. SPL in full space at 3% THD at 1m (averaged between 100 Hz and 6 kHz) |
112.7 dB SPL |
Bass capability: Max. SPL in half space at 3% THD at 1m (averaged between 50 Hz and 100 Hz) |
107.5 dB SPL |
Free field frequency linearity deviation between 100 Hz and 10 kHz |
±0.8 dB |
Max. short term SPL with IEC-weighted noise (IEC 60268-5) at 1 m, in typical listening conditions |
108 dB(C) SPL |
Max. short term SPL with music material at 2.3 m in typical listening conditions (pair / full range) |
100 dB(C) SPL |
Max. short term SPL with music material at 2.3 m, in typical listening conditions (pair with subwoofer) |
106 dB(C) SPL |
Max. long term SPL with pink noise at 2.3 m, in typical listening conditions (single / pair full range) |
88 / 94 dB(C) SPL |
Max. long term SPL with pink noise at 2.3 m, in typical listening conditions (single / pair with subwoofer) |
88 / 94 dB(C) SPL |
Dolby D.A.R.D.T. Max SPL fullrange |
114 dB |
Dolby D.A.R.D.T. Max SPL bass managed |
120 dB |
Recommended Listening Distance |
1.0 … 2.5 m; (3'… 8') |
Feasible Listening Distance |
0.75 … 6.0 m; (2'6"… 18') |
Acoustic principle |
Bassreflex, Ports at the front |
Analog input(s) |
XLR: analog electronically balanced |
Analog input impedance |
24 kOhms |
Max. input level |
+24 dBu for 94 dB SPL setting; +14 dBu for 100 dB SPL setting; +9 dBu for 108 dB SPL setting; -1 dBu for 114 dB SPL setting |
Common mode rejection ratio (CMRR) |
>56 dB @ 15kHz |
Volume control |
via MA 1 software |
Volume control range; resolution |
0 … -∞ dB; 0.1 dB |
Analog dynamic range; THD+N |
118 dB, A-weighted, 90 dB |
Signal routing modes |
analog, S/PDIF L, S/PDIF R, S/PDIF mono |
Digital input(s) |
RCA (75 Ω): S/PDIF |
Digital output(s) |
RCA (75 Ω): S/PDIF |
Max. Input Level; pk-pk, unbalanced / balanced |
1.2 V |
Digital converter: resolution; design |
24 Bit |
Digital converter: sampling rate |
32 kHz..200 kHz |
Digital internal sampling rate |
48 kHz |
Output sample rate |
identical to input sample rate |
Latency ADA / DA |
Analog Input: 2.6 ms; SPDIF Input: 2.1 ms |
Delay: User adjustable delay range |
0 … 120 ms |
Delay: Resolution: time; distance |
20.8 µs |
Delay: Max. frames Audio-video synchronisation (lip sync) |
0 … 120 ms for TOF=0ms, depends on APP implementation |
Delay: Time-of-flight maximum distance |
0 … 120 ms for lipsync=0ms, depends on APP implmentation |
Transport/storage conditions |
-25° C to +60° C (-13° F to 140° F); <90% RH; non-condensing |
Input gain control (sensitivity) |
0 dB ... -15 dB |
Output level control (output level in 1 m based on 0 dBu input level) |
94; 100; 108; 114 dB SPL |
Equalization: Bass |
0; -2; -4; -6 dB |
Equalization: Low-Mid |
0; -2; -4; -6 dB |
Equalization: Treble |
+1; 0; -1; -2 dB |
Input selector |
Analog; S/PDIF L; S/PDIF R; Mono |
Ground Lift |
Yes |
Control |
Local; Network |
Mains Switch |
Yes |
Mains Voltage Select |
Universal Power Supply 100 V~ … 240 V~ |
Controller design |
Digital; active |
Crossover frequency |
1700 Hz |
Crossover slope |
24 dB / octave |
Equalization: via Neumann.Control software |
No |
Automatic room calibration via MA 1 |
Yes |
FIR phase correction |
Linear phase (105 Hz ... 16 kHz; +/- 45°) |
Protection circuitry |
Independent soft clip, peak and thermo limiters for woofer and tweeter; Woofer excursion limiter; thermo limiter for the electronics and amplifiers |
Infrasonic filter: frequency; slope |
38 Hz; 12 dB / octave |
Remote control |
MA 1 software via an RJ45 connector carrying standard IP data |
Display: On; Normal Operation |
Neumann logo “White” |
Display: Identification |
Neumann logo “Rosé” |
Display: Limit / Clip / Errors / Protection /Boot Mute / Shut Down Mute |
Neumann logo “Red” |
Logo Brightness |
via MA 1 software |
Output power woofer amplifier (THD+N with limiter deactivated: 10%) |
145 W |
Output power tweeter amplifier (THD+N with limiter deactivated: 10%) |
100 W |
Output power woofer amplifier (THD+N with limiter deactivated: 0.1%) |
120 W |
Output power tweeter amplifier (THD+N with limiter deactivated: 0.1%) |
80 W |
Mains Power Supply: input voltage; frequency |
100-240 V; 50/60 Hz |
Power consumption (230 V / 100 V): Standby |
0.3 W |
Power consumption (230 V / 100 V): Idle |
15 W |
Power consumption (230 V / 100 V): Full output |
320 W |
In-rush current (Peak) |
33 A |
Standby |
automatic, 90 mins (default); user defined in software |
Cabinet material |
Composite polycarbonate front and rear, wooden sleeve |
Cabinet surface finish; color (front / back) |
Painted, White (RAL 9016) / White (RAL 9016) |
Operating conditions |
+10° C to +40° C (+50° F to +104° F); <75% RH, non-condensing |
Woofer |
165 mm (6.5") with protecting white metal grille |
Tweeter |
25 mm (1") with protecting white metal grille |
Mounting points |
2 x M6 threaded inserts with 70 mm spacing on back panel; thread depth 15 mm; (5/8”) |
Product dimensions (height x width x depth) |
345 x 225 x 273 mm; (13.58" x 8.86" x 10.75") |
Internal net volume |
12.6 l |
External net volume |
20.4 l |
Packed dimensions (height x width x depth), mm (inches) |
480 x 303 x 403 mm; (18.9" x 11.9" x 15.9") |
Product weight |
8.0 kg; (17 lbs 10 oz) |
Packed weight |
9.4 kg; (20 lbs 12 oz) |
Packaging weight inc. Cables and manuals |
1.41 kg; (3 lbs) |
Packed cube |
0.059 m³; (2.08 ft³) |